The chassis armor divides two steps to carry on: First, clean, promotes with the elevator the automobile body, carries on the clean with the cleansing agent to the chassis, the silt, the greasy dirt and other sundry goods cleans, reveals the original metal surface. Second, on chassis a spray coating sol elastic protector. This kind of spray coating may carry on many times may also a spray coating. The multiple spray coating takes time relatively, but solidifies is quite quick. A spray coating is convenient, but solidifies slowly, the actual result is the same. After the spray coating, certainly must wait till the table to do, namely the surface already did not interfere, can drive away the vehicle. The surface complete dry probably needs for 4 hours.
Within one week of the application, please notice not to flush the chassis as far as possible when wash the car, bumps into the road surface to have the water to pass as far as possible by the low speed travel, reduces the water to splutter the chassis. Such chassis armor's coating will be quicker does!
Actually many chassis itself are the black. After having spurted the chassis armor, just has spurted the multi-layer protective finish on the chassis, will not affect vehicle's own artistry. Moreover after having constructed the 3M chassis armoring material, on the motor car chassis is not easy to stick the sludge, changes in the maintenance!
Will go to the spray coating in the normal condition according to the following method not to fall off, certainly its dry speed great speed also and weather will then have the relation general clear celestial stems speed to be able to be quicker!
a. The confirmation waits the spray coating region clean, not to have the fat and the corrosion. Simultaneously also confirmed that this region is completely dry guarantees the coating the adhesion and the effect.
b. Tighten the screws & blots on the car body.
c. Prevent other region use motor car chassis rust prevention sound-insulated anti-collision rubber masking tape and the camouflage paper camouflage to spurt does not work as the spot.
d. Uses the spray gun, the spray coating should be slow and be stable, reaches thickness which the redundant spray coating to thickness needs.
The spray coating all metal surface to 1/8 吋 thickness, the recommendation spray coating spot is as follows:
a. The fan blade, the broken stone anti-collision board and the fan blade backing, the fan blade and the automobile body intersection point will increase spray coating quantity this to be helpful in prevent the plate work to become less crowded with the reduced noise.
b. Gas box.
c. First encircles and in the fan blade the board.
d. Floor.
e. Rear bumper inside.
f. Bonnet inside.
g. Suitcase.
Other easy rusty regions to produce the high temperature oil sump or the exhaust pipe for example should not spurt! This will not have the unusual smell generally.
